User`s manual

Before You Use
vii

Multiple Virtual Servers (e.g., Web, FTP, Mail servers) can be setup on user’s local network.

Static routes, RFC1058 RIPv1, RFC1723 RIPv2.

DNS Relay and DNS Server
*3

ARP Proxy
Security Features

PAP (RFC1334), CHAP (RFC1994) for PPP session

Firewall support IP packets filtering based on IP address/Port number/Protocol type and TCP code field flags

Intrusion Detection provides protection from a number of attacks (such as SYN/FIN/RST Flood, Smurf,
WinNuke, Echo Scan, Xmas Tree Scan, etc)

WEP (Wired Equivalent Privacy) encryption uses RC4 with 64/128 bit key length (for wireless ADSL router only)
Wireless LAN Features

Fully compatible to IEEE 802.11b standard and allow operating range up to 300 meters (open space) and 100
meters (indoor).

The Direct Sequence Spread Spectrum (DSSS) technology is exploited.

Seamless roaming within the 802.11 and 802.11b wireless LAN infrastructure

Low power consumption via efficient power management
Configuration and Management

User-friendly embedded web configuration interface with password protection

Remote management accesses control

Telnet session for local or remote management

HTTP firmware upgrades via web browser GUI directly

Distribute IP addresses to end users via DHCP server provided by ADSL router

SNMPv1/v2c agent with MIB-II, PPP MIB, ADSL Line MIB.
Note:
*1 This is optional. TR-037 Autopvc provisioning can be provided on demand.
*2 This is optional. UPnP IGD and NAT Traversal function can be provided on demand.
*3 This is optional. DNS server can be provided on demand.
System Requirements
For using this, you have to make sure you have the following that installed on the clients:
For Ethernet Clients

Operating System must be Windows98/2000/NT/ME/XP

10/100 Base-T NIC

10/100 Base-T(UTP) network cable

A Hub
For USB Clients

Operating System must be Windows98/2000/NT/ME/XP

USB cable