User`s manual

Chapter 5: Web Configuration
59
By default, RIP is disabled with
Disabled
selected. You are allowed to enable RIP over the primary LAN interface.
Upon each interface, you can customize the RIP on
Receive Mode
and
Transmit Mode
respectively.
Receive Mode
: It incorporates the RIP information when receiving the RIP packets. From the drop-down list
select which RIP version should be accepted, RIP disable, RIPv1, RIPv2 and both.
Transmit Mode
: It broadcasts the routing table. From the drop-down list select which RIP version should be
broadcasted, RIP disable, RIPv1, RIPv2 and both.
D
D
N
N
S
S
DNS Relay
On this page you can choose to disable or enable DNS Relay function. If your DNS is disabled and you choose to
enable DNS relay, after selecting the
Enabled
option, please click
Configure
and then specify up to three DNS IP
addresses in the
DNS server 1-3 IP address
fields. Then click
Apply
to enable the DNS relay function.
While the ADSL supports DNS Relay, it is regarded as a DNS server that is responsible for forwarding the name
address inquiry for the host. On the Router mode, the manager must type in the DNS server address of the ISP
manually. For example, if you are the first time to log in DNS Relay page, when you choose Enabled and enter this
page by clicking
Configure
, the page will show
DNS server 1-3 IP address
fields. Enter the addresses and click
Apply
.
Yet, on MER, PPPoA or PPPoE mode, ADSL will get the DNS server address automatically from ISP. The manager
does not need to type in the DNS server address. Simply click Enabled item On DNS Relay settings and leave the
address entry lines blank. Finally, click Apply. DNS Relay will be invoked.