User`s manual

ADSL Router User Manual
4
6. Connect the supplied power adapter to the
PWR
port of your ADSL Router, and plug the other end to a power
outlet.
7. Turn on the power switch.
Note:
For Full Rate (G.dmt) standard, a POTS Splitter is necessary on subscriber’s premise to keep
the telephone and ADSL signals separated, giving them the capability to provide
simultaneous Internet access and telephone service on the same line. To connect a POTS
Splitter:
1. Connect the port Phone to your telephone.
2. Connect the port Modem to your ADSL Router.
3. Connect the port Line to the ADSL wall jack.
USB Driver Installation
If the ADSL Router is connected to a PC through USB interface, you will be prompted for the USB drivers when
plugging the USB cable to the PC. Refer to the relevant operating system to install the USB drivers. Otherwise, you
may skip this chapter.
F
F
o
o
r
r
W
W
i
i
n
n
d
d
o
o
w
w
s
s
9
9
8
8
Step 1 When plugging the USB cable to the PC, the system will automatically detect the
Askey USB ADSL
Router
. When
Add New Hardware Wizard
window announces detecting of the USB device, click
Next
.
Note: If the USB device is not detected, check the USB cable between the PC and the
device. Also verify that the device is power on.
Step 2 When prompted for driver files, select
Search for the best driver…
and click
Next
.