ADSL2+ Modem Router User Manual
Table Of Contents
- Version 2.3
- For Installation
- For Using
- For Service
- Caution
- ARP (Address Resolution Protocol )
- DHCP (Dynamic Host Configuration Protocol)
- LAN (Local Area Network) & WAN (Wide Area Network)
- NAT (Network Address Translation) IP Address
- Private IP Address
- Public IP Address
- PVC (Permanent Virtual Circuit)
- UDP (User Datagram Protocol)
- Virtual Server
- VPI (Virtual Path Identifier) & VCI (Virtual Channel Identifier)
Chapter 2: System Requirement and Installation
Method Two – Run a silent installation.
n Copy the USB driver folder from the driver CD to somewhere on the PC. (In
our example, the driver files are put under D:\Askey ADSL USB WHQLed.)
o Open Start menu, key in cmd in the blank and press enter. Then click cmd.
2
1
p When the Command Prompt screen appears, point to the driver folder on
your PC, and then enter setup -s. Press enter to start silent installation.
q The system will install the driver automatically. You can connect your router
and the PC with a USB cable now.
r The system will detect the USB driver automatically.
Note: If the USB device is not detected, check the USB cable between the
PC and the device. Also make sure that the device is power on.
s After the file copying finished, a completing message will appear.
t You can use the router now.
13