User manual

ADSL Bridge/Router User's Manual
62
For communication with your ISP or a remote LAN, select the
corresponding ppp, eoa, or other WAN interface.
4. Select a metric value (hop count) for the interface. You can
select any integer from 1 to 15.
5. Select a Send and Receive Modes.
The Send Mode setting indicates the RIP version this
interface will use when it sends its route information to other
devices.
The Receive Mode setting indicates the RIP version(s) in
which information must be passed to the RTA100+ ADSL
Modem/Router in order for it to be accepted into its routing
table.
RIP version 1 is the original RIP protocol. Select RIP1 if you
have devices that communicate with this interface that
understand RIP version 1 only.
RIP version 2 is the preferred selection because it supports
“classless” IP addresses (which are used to create subnets)
and other features. Select RIP2 if all other routing devices on
the autonomous network support this version of the protocol.
6. Click
Add
.
The new RIP entry will display in the table.
7. Click the
Enable
radio button to enable the RIP feature.
8. When you are finished defining RIP interfaces, click
Submit
.
A page displays to confirm your changes.
9. Select
Admin
>
Commit & Reboot
and click
Commit
to
save your changes to permanent storage.
#!
To view the RIP statistics, select
Services
>
RIP
>
Global Stats
: