User manual

Error! Style not defined.. Error! Style not defined.
57
The pass rule must be assigned a rule ID that is a lower number
than the ID assigned to the rule it is intended to pass. In you want
a specific IP address or range of addresses to not be subject to an
existing rule, say rule ID #5, then you can create a pass rule with
ID #1 through 4.
1. Display the NAT Rule – Add Page, choose a Rule ID, and
select
Pass
as the Rule Flavor.
2. Select the interface and, if desired, a protocol that this rule
applies to.
3. In the
Local Address From
and
Local Address To
fields,
type the lowest and highest IP addresses that define the
range of private address you want to be passed without
translation.
If you want the pass rule to act on only one address, type that
address in both fields.