User manual

Error! Style not defined.. Error! Style not defined.
23
Field Description
VCI and VPI Enter the VPI/VCI values given by your ISP.
Bridge This setting enables or disables bridging
between the RTA100+ ADSL Modem/Router
and your ISP. Your ISP may also refer to this
using “RFC 1483” or “Ethernet over ATM”.
IGMP This setting enables or disables the Internet
Group Management Protocol. Contact your
ISP whether to enable this setting.
IP Address
and Subnet
Mask
If your ISP has assigned a public IP address to
your LAN, enter the IP address and the
associated subnet mask in the boxes provided.
Otherwise keep the default 0.0.0.0/0.0.0.0.
Default Route When enabled, the IP address specified above
will be used as the default route for your LAN.
Gateway IP
Address
Specify the IP address that identifies the ISP
server through which your Internet connection
will be routed.
Username
and
Password
If you select PPP as the Encapsulation type,
enter the username and password you use to
log in to your ISP.
Use DNS Click Enable to turn on the DNS forwarding
service, which forwards to your LAN PCs the
DNS server addresses that your PPP
connections learns from your ISP.
This option can only be used when the
RTA100+ ADSL Modem/Router acts as a
DHCP server for your LAN.
Primary/
Secondary
DNS Server
You may just keep the default 0.0.0.0.
If you enter the Primary and Secondary DNS
addressed given by your ISP, these DNS
servers will be used in addition to any DNS
servers discovered automatically.
After completing the required settings, click
Submit
.
Then go to
Admin
>
Commit & Reboot
and click
Commit
to
store your changes to permanent memory.