User manual
7
3
Using a PC Connected to the USB port
This chapter describes the instructions to use a PC to connect to
the RTA100+ ADSL Modem/Router’s USB port. If your model
does not come with a USB port, just ignore this chapter.
If you use the RTA100+ ADSL Modem/Router’s USB port to
connect to a PC, you must first connect the USB cable and then
install the provided USB driver software on the PC. The driver
enables Ethernet-over-USB communication with the RTA100+
ADSL Modem/Router. Make sure to take the steps as described
below.
The strings description below are basically the same in Windows
98, Me, 2000 and XP. The following assumes a Windows 2000
environment.
Part 1. Attaching the USB cable.
Attach the USB cable to the RTA100+ ADSL Modem/Router and
to your PC.
After attaching the USB cable, the Windows plug-and-play
function will issue a hardware wizard requesting the USB driver.
Click
Cancel
to bypass the screen.
Part 2. Installing the USB driver.
1. Insert the provided Software Utility CD into your CD-ROM
drive.
2. Locate the USB installation files on the Software Utility CD
and double-click on
setup.exe
to launch the installation
program. The setup program is not operation system
specific; Windows 98, Me, 2000 and XP use the same
setup program.