User manual

Error! Style not defined.. Error! Style not defined.
5
Step 3. (Optional) Connect to a USB PC.
If you use the device’s USB port to connect to a PC, refer to next
chapter for instructions.
Step 4. (Optional) Connect the CONSOLE port.
For the initial configuration of the device, you can connect a PC to
the device through the console port and use terminal emulator
software on the PC. Connect the round end of the RS-232 cable
to the port labeled
CONSOLE
on the rear panel of the device.
Then connect the 9-pin end to a serial port of your PC.
Step 5. Attach the power connector.
Connect the AC power adapter to the PWR connector on the back
of the device and plug in the adapter to a wall outlet or power strip.
Step 6. Turn on the RTA100+ ADSL Modem/Router and power
up your systems.
Press the power switch on the back panel of the device to turn on
the device.
Turn on and boot up your computer(s) and any LAN devices such
as hubs or switches.
The following diagram illustrates a connection example: