Instruction Manual

an RPM indicator/tachometer operating from one of the

proportional outputs of the SST-2000A/H:

an independent meter mounted elsewhere on or near the engine.

2 Wait for the RPM to stabilize.

3 When RPM is stable, select the appropriate set point trim pot .

4 Follow the procedure in Alternate Method 1: steps 1-10.

Alternate Method 3: Adjusting individual set points in high noise

areas

If high ambient noise makes it impossible to hear the relay click:

1 Disconnect the wire from:

the center post of the SST-2000A/H set point relay being

adjusted.

either one of the other two contacts on the same relay.

[Mark the wires or position them so they can be correctly

reattached.]

2 Connect an ohmmeter to the center terminal of this relay and to

either one of the other terminals of this relay. [If adjusting Relay 1,

connect the ohmmeter to terminals 18 & 17 or 18 & 19.] The

ohmmeter will indicate either a short or an open condition

depending on which terminals are chosen.

3 Adjust the relay as outlined in Method 1: 1-10. When the relay trips,

the ohmmeter will show a short or an open, opposite to the

indication it had before the relay tripped.

4 Reattach the wires to the relays.

5 Repeat the above procedure for other set points to be changed.

Chapter 4