User manual

90 of 148
The controller can be made to NOT sound the alarm when the controller is not in
the AUTO mode. This is controlled by the Not In Auto setting. “Disable Beep”
is the default selection.
The OFF Mode Start setting can be set to Enable to allow a manual start from
the OFF mode. Otherwise a manual run can only be performed when the
controller is in the AUTO mode.
Table 23 – Basic Setup Menu
Menu
SELECTION AND RANGE
Default
Contrast Adjust
5-95 %
50%
Page Roll Delay
1-10 s
2s
State Roll Delay
1-10 (1 is shortest delay, 10 is longest)
2s
Sleep Delay
10-600s. Shorter is ideal to extend the
backlighting life.
600s
Maintenance
Read only. Displays the amount of hours
until next service if this feature is enabled.
If service is overdue the hours become
negative.
N/A
About GSC400
Read only. Displays the GSC400
hardware version, software (firmware)
version, and serial number.
N/A
Not In Auto
Disable Beep, Enable Beep
Disable
Beep
OFF Mode Start
Disable, Enable
Enable