User manual

86 of 148
Off key pressed during Manual Run
If the Off key is pressed during a manual Run, a cool down popup will display on
the GSC400. Press the AUTO key to immediately enter the Auto mode, press
the OFF key to immediately enter the OFF mode, or press the Enter key to enter
cool down. If no key is pressed the GSC400 will remain in the Run mode.
If the OFF key is pressed during another start condition (e.g. Modbus Run) a cool
down popup will appear again but in this case the only option is to press the OFF
key to immediately enter the OFF mode.
4.6 Exercising
If the GSC400 is programmed to exercise it must be in the AUTO mode to do so.
If it is in the OFF or RUN modes it will skip the exercise cycle.
If the GSC400 is unpowered then powered up, on power up, the GSC400 will use
the start date and month to determine the next time to exercise instead of the run
duration. See section 3.11 on page 72 for the exerciser settings.