User manual

73 of 148
3.12 Password Setup
The GSC400 allows a 4 digit
password to be entered to protect
the advanced setup menu from any
unauthorized changes. This
password will be needed to
perform any changes to the
advanced setup. If the password is
entered incorrectly, the controller
will allow 3 more tries before the
GSC400 returns back to the main
menu.
To set each digit of the password, do the
following:
 Select Password No.1 (Digit 1)
Enter the desired number 0-9
 Select Password No.2 (Digit 2)
Enter the desired number 0-9
 Select Password No.3 (Digit 3)
Enter the desired number 0-9
 Select Password No.4 (Digit 4)
Enter the desired number 0-9
Remember to write down the password
for future reference. The default
password is all zeros.
You can only reset the password using
the GSC400 PC Interface. To reset the
passwords click on “Load Factory
Defaults” under File in the top menu.
This will reset ALL settings to their
factory default so make sure to record
the controller settings before doing this.