User manual
53 of 148
Open Sender Detection or Shorted Sender Detection provides diagnostics on
the sender. See the installation chapter for more details. Set to Warning, Failure,
or Disable.
When changing the units, the controller will do a conversion of all settings to the
new unit. It is possible that the conversion will cause one or more settings to go
out of bounds.
3.4.4 Low and High Engine Temperature
The Low and High Engine Temperature types can share the same sender. To do
this set both to the same input pin as follows:
1. Set the High Engine Temperature to the desired pin (e.g. Analog2). You
will see a checkmark beside Analog2.
2. Set the Low Engine Temperature to the same pin. You will see a dash
beside the one occupied by High Engine Temperature. Select the same
pin and the dash will turn into a checkmark.
If the high engine temperature and low engine temperature are already set to the
same input pin you will only see a checkmark in each.
3.4.5 Fuel Level Sender
You will need to know the resistance of the sender at 0%, 25%, 75%, and 100%
fuel levels. The resistance values must be either monotonically increasing (e.g.
1, 2, 3, 4, 5) or monotonically decreasing (e.g. 5, 4, 3, 2, 1).
In the Fuel Level menu (located in the Advanced Setup menu) you will also need
to set the controller type or hardware version (LS/LX, or LSB/LXB). The
controller hardware version can be found on the back label (under the bar code).
If you have LSC/LXC then chose LSB/LXB. Section 1.4 on page 12 explains
how to read the product number.
3.4.6 Auxiliary Analog 1 and 2
This feature is only in firmware versions 2.06 and above.
In addition to the six standard sensor types, there are two customizable types.
They can be set to a Switch or Sender and have some of the same settings as
the standard types. They appear in the Advanced Setup menu as: “Aux Analog
1” and “Aux Analog 2”.
They also have the following unique settings:
They can be programmed to display custom text with the PC Configurator.
The default text is “Aux An1” and “Aux An2”. It is not possible to set from
the front panel.