User manual

46 of 148
occurs.
Exerciser Set
Generators require periodic operation as
part of their scheduled maintenance. This
menu allows settings to control how often
the engine/generator is started and for
how long.
3.11 (72)
Inputs Setup (i.e.
Configurable Switched
Inputs)
This menu allows you to assign
features/warnings, for example low oil
pressure, to one of eight digital inputs.
3.9 (67)
Battery Setup
This menu controls the settings for the
battery under and over voltage warnings
and failures. It also allows the user to set
at what battery voltage to start the
generator and how long the generator is
to remain running.
3.6 (57)
Set Password
The advanced menu requires a password
for access. The user can change the
password here. The default password is
0000.
3.12 (73)
Set Maintain
This menu controls the service notification
feature for regular maintenance. The
user can enable/disable the feature and
set the service interval. A technician can
reset the service interval here. On reset
the service counts down to the next
service.
3.13 (74)
Set Modbus
This sets the modbus slave address and
baud rate.
3.14 (74)
Common Faults
The user can select a group of failures,
warnings, and events that when triggered
will cause a digital output to turn on. The
user also needs to select this feature in
the digital outputs menu for one of the
outputs.
3.15 (74)
Other Settings
This contains settings to control the
following features:
1. Dummy Load – Places load on
genset to prevent a no or low load
condition.
2. LCD Heater (“-H” hardware option
only, consult factory)
3. Fan Control – Activate
configurable switched output when
engine temp is above a certain
value.
3.16 (75)