User manual

44 of 148
The GSC400 incorporates an Advanced Setup menu. Only OEMs or
knowledgeable users should change these parameters.
Before entering the Advanced menu a
password is required. The password
consists of a four digit number. Each
number needs to be selected using the
up or down arrows on the GSC400.
Simply choose the correct password
number for each selected position by
scrolling to the proper number followed
by the Enter key. The default password
is 0 0 0 0. The password may be
changed anytime. See Password Setup
section on page 73.
The Advanced Setup menu on the
GSC400 is shown to the right.
See Table 6 below for a list of the
various submenus in the Advanced
menu and a description of each.
Appendix A on page 105 lists the
various submenus, the settings they
contain, and the range of each setting.
3.1 Making Menu Selections
In some menus you are required to make a selection from a list of options. Once
you are in the menu the current active selection will have a checkmark beside it.
You may need to scroll up or down using the Up and Down Keys to see it.
Important!
For Firmware Versions Below 2.00
After changing any settings on the controller, the controller needs to be reset. This
can be done one of two ways:
1. Power off, wait for 2s, and power on the controller.
2. Press the Run key, wait until the controller begins the start sequence and then
press the OFF key. You will see a flickering of the screen as the controller
updates.