User manual

25 of 148
2.6.2 Senders
The sensor types Dynagen supports out of the box for engine temperature and
oil pressure are given in the following table. Fuel Level, Oil Level, and Fuel in
basin types are not supported out of the box; the PC Configurator must be used
to store a custom table for these types.
Table 4 – Default Senders for Temperature and Oil Pressure
Sender Manufacturer and
Part Number
Type
Supported
Pins on J2
Sensing Range
Datcon High Range
(DAH)*
High Temp.
3 and 4
129 to 330
0
F
2
72 to 267
0
F
VDO 323-421
High Temp.
3 and 4
77 to 266
0
F
Datcon 2505-00 or
STEWART & WARNER
279B-F*
Low Oil Pres.
3 and 4
0 to 99 PSI
VDO 360-004
Low Oil Pres.
3 and 4
0 to 99 PSI
Sensata 67CP-
0320150GFNA0C
Low Oil Pres.
(Electronic)
6
0 to 100 PSI
The table above applies to controllers with firmware version 2.04.06 and above.
Other firmware versions do not support Datcon on pin 2 or Sensata out of the
box. The PC Interface is required.
(1) The senders Dynagen supplies as part of the GSC400 starter kit (optional)
have a * beside the name.
(2) If the high engine temperature sender is set to pin 3 or 4 do not enable the
shorted sender detection features.
(3) Dynagen supplies and recommends the Sensata oil pressure sensor for
heavy duty or 24/7 applications.
(4) The GSC400 will only display the minimum or maximum value of the range
for readings below or above the Sensing Range respectively.
(5) Although the GSC400 supports the VDO oil pressure sender above, VDO
does not warranty their senders if used in electronic controls such as the
GSC400.
The following table lists the defaults for the Auxiliary Analog 1 and 2:
Table 5 – Default Senders for Auxiliary Analog Inputs 1 and 2
Sender
Type
Supported Pins (J2)
Datcon High Range (DAH)
Temperature
3 and 4
Datcon 2505-00 /
STEWART&WARNER
279B-F
Pressure
3 and 4
Note: there is no default stored for Level types. You must use the PC
Configurator to store a custom table.