User manual

120 of 148
Appendix D Accessory List
D.1 GSC400 Controller Harness - Accessories
The following table identifies all the wiring harnesses as part of the GSC400
controller:
Table 29 – GSC400 Wiring Harness Part List
Harness
Description
Stock Code
Harness Length
Circuit Numbers
(Pins) PopulatedP
2
P
AC Current
Sensing*
DWG1375R2-5
5 Feet
1, 2, 3
Digital Input*
DWG1378R2-5
5 Feet
All circuits
Analog Input*
DWG1376R2-5
5 Feet
1, 2, 3, 4
J1939
DWG1373R3-5
5 Feet
1, 2, 3, 4
Digital Output
DWG1377R2-5
5 Feet
4, 7, 8, 9P
1
P
, 10, 11,
12P
1
P
Modbus
DWG1454
5 Feet
1, 2, 3 P
3
P
Pack of 5
Wires
DWG1410R2-5
5 Feet
Wires with crimps
as not all I/O are
populated in above
harnesses.
*The AC Current Sensing, Digital Input and Analog Input Harness can be
purchased together as a starter kit: Stock Code ACC0086. See section
Appendix G on page 147 for the drawing.
P
1
P
Circuits 9 and 12 are tied together. This disables the emergency stop input.
Users who desire this feature can cut this wire and route it to a switch.
P
2
P
See Figure 4 on page 17 for information on pin numbers.
P
3
P
This harness also provides power and ground for modbus devices via
connections to the GSC400 extra power and ground terminals.
D.2 GSC400 Programmer
The GSC400 programmer can be used to configure the GSC400 settings
(instead of using the front panel menu) and load new firmware (software for the
GSC400 that gives it new feature, performance improvements, or bug fixes).
Table 30 – GSC400 Programmer Part List
Programmer Description
Stock Code
USB/Serial Programmer
GSC400-PGMRC