User manual

110 of 148
Set Password (Four
Digits Long)
Password No. 1 (Digit 1)
0-9
Password No. 2 (Digit 2)
0-9
Password No. 3 (Digit 3)
0-9
Password No. 4 (Digit 4)
0-9
Set Maintain
Reset Counter
No, Yes
Enable Counter
Disable, Enable
Count Interval
10 to 1000 Hours in 10 hour
increments.
Set Modbus
Device Address
1 - 247
Baud Rate
9600, 19200, 38400, 57600
Common Faults
Failure Table 1
Warning Table 1
Events Table 1
Failure Table 2
Warning Table 2
Events Table 2
Failures: Disable, Over Crank,
Locked Rotor, HighEngineTemp,
LowOil Pressure, Over Speed,
Low Fuel Level, Oil Level, Low
Coolant, Low Air Pres, Low
Hydraulic, Auxiliary Fail, Low
Battery, High Battery,
UnderSpeed, Under Voltage, Over
Voltage, Over Current, Loss of
ECM, EPS Load Fail, Config Fail
1, Config Fail 2
Warnings: Disable,
HighEngineTemp, LowOil
Pressure, Over Speed, Low Fuel
Level, Oil Level, Fuel In Basin,
Auxiliary Warn, Charger Fault,
Low Battery, High Battery, Under
Speed, Under Voltage, Over
Voltage, Over Current, LowEngine
Temp, High Fuel Level, Config
Warn 1, Config Warn 2
Events: Disable, EPS Load On,
Idle Running, Service Needed,
Not In Auto, LoBatt InCrank
Other Setting
Dummy Load
Disable, Enable
Dummy Load Dly
10 – 120s
Dummy Load On
0 – 500A
Dummy Load Off
LCD Heater
High Fan On
Fan Switch Dly
0 – 500A
Disable, Enable
20
0
C to 120
0
C in 1
0
C increments
1 – 120s in 1s increments