User manual

11 of 148
1.3 Receiving, Handling, and Storage
Receiving:
Every effort is made to ensure that your GSC400 gen-set controller arrives at its
destination undamaged and ready for installation. The packaging is designed to
protect the GSC400 internal components as well as the enclosure. Care should
be taken to protect the equipment from impact at all times. Do not remove the
protective packaging until the equipment is at the installation site and ready to
be installed.
When the GSC400 reaches its destination, the customer should inspect the
shipping box and controller for any signs of damage that may have occurred
during transportation. Any damage should be reported to a DynaGen
representative after a thorough inspection has been completed.
A shipping label affixed to the shipping box includes a variety of product and
shipping information, such as items and Customer numbers. Make certain that
this information matches your order information.
Each GSC400 controller is packaged in its own box. Do not discard the packing
material until the controller is ready for installation.
Handling:
As previously mentioned, each GSC400 gen-set controller is packaged in its
own individual box. Protect the equipment from impact at all times and do not
carelessly stack. Once the controller is at the installation site and ready to be
installed, the packaging material may be removed.
Storage:
Although well packaged, this equipment is not suitable for outdoor storage. If the
GSC400 is to be stored indoors for any period of time, it should be stored with its
protective packaging in place. Protect the controller at all times from excessive
moisture, dirty conditions, corrosive conditions, and other contaminants. It is
strongly recommended that the package-protected equipment be stored in a
climate-controlled environment of -20 to 65°C (-4 to 149°F), with a relative
humidity of 80% or less. Do not stack other equipment on top of the stored
controllers.