User manual

Installation and User Manual for the GSC400 PC Software Interface
6
5. Click Install to continue setup
installation which will install the
program to the confirmed locations.
Click Back to make changes.
6. A process bar displays the software
being copied to your hard drive. This
may take several minutes depending
upon the speed of your computer and
CD-ROM drive.
Press Cancel to abort setup.
7. Upon successful installation, the
following screen will be displayed.
Click finished
You have successfully installed the GSC400 PC interface. If you have encountered any
problems or errors while installing the software, please refer to Troubleshooting
Guidelines on page 33
or call DynaGen technical support Hot Line at 1-902-562-0133.