User manual

Installation and User Manual for the GSC400 PC Software Interface
4
PC INTERFACE SOFTWARE INSTRUCTIONS
Section 1 – Welcome
The GSC400 PC software interface is a program which allows programming and
customization to DynaGen’s GSC400 Engine Controllers. The GSC400 can be
programmed manually via front panel buttons OR with the easy-to-use PC software
interface which allows customization of inputs, outputs; AC sensing, engine logic
settings, and much more. The GSC400 may be configured for common and advanced
parameters from the front panel buttons or by using the PC software interface allowing a
quick, user friendly display interface.
Section 2 – Installing the GSC400 Software
2.1 – Before you begin
In order to install and use the DynaGen software, you should have a basic
understanding of how to use your computer. If you do not, we recommend that you ask
someone who does to help you, or that you read the user manual that came with your
computer.
If you encounter any problems or errors while installing the GSC400 software, please
refer to Troubleshooting Guidelines On page 33.
2.2 – Minimum Hardware Requirements
For the DynaGen GSC400 software to work reliably and efficiently, your computer must
meet or exceed the minimum requirements specified in the following table:
Operating System
Windows 98SE, 2000, ME,
XP.
Processor Pentium or equivalent
processor
Memory 64 MB RAM
Hard Drive 20 MB Free Disk Space
Video card display 256 colors at 1024x768
Peripherals CD-ROM Drive
Port RS232 Serial (COM) Port
Or USB (with adapter)*
*USB-Serial adapter required