User manual

Installation and User Manual for the GSC400 PC Software Interface
16
4.3.3 – Digital I/O
The GSC400 Digital I/O screen allows
configuration to the following:
Digital Input: Digital Output:
1. Input A 1. Output A
2. Input B 2. Output B
3. Input C 3. Output C
4. Input D 4. Output D
5. Input E 5. Output E
6. Input F 6. Output F
7. Input G 7. Output G
8. Input H 8. Output H
Digital Input:
Digital Input Setup
All selections apply to
each individual input
Input A (Bat=Fail)
Disable, Low Air Pressure
Input B (Bat=Fail)
Low Hydraulic Pressure,
Input C (Bat=Fail)
EPS Supply Load
Input D (Bat=Fail)
Alarm Silence, Low Coolant,
Input E (Gnd=Fail)
Volt Select 1, Volt Select 2,
Input F (Gnd=Fail)
Idle Mode, Start/Stop
Input G (Gnd=Fail)
Auxilary Warn/Failure
Input H (Gnd=Fail)
Digital Output:
Digital Output Setup
All selections apply to
each individual output
Extra Relay Disable, Warm-Up, ETS,
Output A Pre-heat, Cooldown,
Output B Over Crank , High Temp Fail ,
Output C High Temp warn, Low Oil Fail ,
Output D Low Oil warn, Under Speed Fail,
Output E Under Speed Warn, Over Speed Fail
Output F
Over Speed Warn, Low Fuel Fail
Output G
Low Fuel Warn, Battery Fail,
Output H
Battery Warn, Low Coolant Fail,
Low Coolant warn, Not in Auto,
Failure, Crank Rest,
Engine Running, Crank On,
Exerciser Alarm, Recharge Alarm
Under Volt Warn, Over volt warn,
Over Amp Warn, Fuel in Basin,
Volt Regulator, Low Temp Warn.
Back Light, Aux Warn.