User Manual
Die-Cut Pattern
1 REQ.
CHPGIPW06
1/16" X 3-3/8" X 16" PLY
CHPGW05
Note: If you will be building functional flaps for your
Chipmunk, glue in the lightening holes in ribs W4
and W5.
Note: This page shows the location of the die-cut
parts for the wing. Not all parts are marked on the die
sheets. Be sure to mark all parts with a ball point pen
prior to removing them from the die sheets.
2
REQ,
1/8" X 5-3/8" X 20-5/8" PLY
CHPGW04 2 REQ.
3/32" X 3" X 18" BALSA
CHPGW03A 2 REQ.
3/32" X 3" X 30" BALSA
CHPGW03 2 REQ.
3/32" X 3" X 30" BALSA
CHPGW02 2 REQ.
3/32" X 3" X 30" BALSA
CHPGW01 2 REQ.
3/32" X 3" X 30" BALSA
7