Owner`s manual

6
STEP 2: HANDLEBAR PLACEMENT
The handlebars are held in place by spring loaded buttons.
TO INSTALL HANDLEBARS:
A. Position the handlebars so that the
button is aligned with the hole located
on top of the steering tube.
B. While pressing the button, push the
handlebar end into the steering tube
until the button “clicks” into the hole of
the steering tube.
WARNING
Failure to properly tighten the steering height adjustment clamp can result
in improper handlebar movement and loss of steering control.
POP BUTTON
STEERING TUBE
HANDLEBAR END HOLE
STEP 3:
Place hand on steering tube above
front wheel. Push down and forward
to release the lock.
Your scooter should look like this. Step 5: Close clamp.
STEP 4:
Rotate steering tube upright into
verticle riding position until you hear a
“click”. This means the steering tube
is locked into place.