User Manual

2. HANDLEBAR ASSEMBLY

• Turn the ride-on toy upright.

• Insert the handlebar assembly together with wire into the large opening at the

front of the ride-on toy as shown.

• Turn the ride-on toy on its side.

• Ensure that the steering column is placed through the hole in the steering linkage

attached to the front axle.

• Install a Ø10 washer and M10 locknut, and then tighten them with the provided

socket wrench.

3. POWER SUPPLY CONNECTION

NOTE: The battery is disconnected for shipment to prevent the battery from

draining.

• Insert the handlebar connector through the hole in the ride-on toy body as

shown.

• Turn the ride-on toy back upright.

• Plug the handlebar connector into the control module connector as shown.

Handlebar

Connector

Control

Module

Connector

Handlebar

Connector

Steering Linkage

M10

Locknut

Ø10

Washer

Steering Column