OWNER’S MANUAL 6V LITTLE QUAD this manual contains important safety, performance and maintenance information. read the manual before taking your first ride or allowing your child to ride your new electric ride- on toy. keep the manual handy for future reference. DO NOT return this item to the store.
TABLE OF CONTENTS A Introduction, Safety and Warnings. . . . . . . . . . . . . . . . 2 B Before You Begin Assembly. . . . . . . . . . . . . . . . . . . . 6 C Parts Diagram. . . . . . . . . . . . . . . . . . . . . . . . . . 7 D Assembly. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 E How to Use Your Ride-on Toy . . . . . . . . . . . . . . . . . . 13 F Detailed Maintenance and Repair . . . .
INTRODUCTION, SAFETY AND WARNINGS A ABOUT THIS MANUAL: This Manual was written to help you and your child get the most performance, comfort, enjoyment and safety when riding your new electric ride-on toy. It is important for you to understand your new electric ride-on toy. By reading this manual before you let your child go out on his/her first ride, you will know how to get the most from your new electric ride-on toy.
RIDER USE AND REQUIRED PARENTAL SUPERVISION RIDERS MUST NOT EXCEED THE WEIGHT LIMIT OF 40 lb (18 kg) and MUST BE OVER 18 MONTHS OLD. The age grade for the electric ride-on toy is for ages 18 – 36 months. Just because your child is within the age and weight limitations specified for the electric rideon toy, does not mean that his/her size is appropriate to fit or maintain control of the electric ride-on toy, or that he/she is capable of safely operating the electric ride-on toy.
SAFE RIDING PRACTICES AND WARNINGS • Check and obey all local laws or regulations which may be in effect in the locations where the electric ride-on toy may be used. • Always wear appropriate clothing and shoes. • Observe the age and weight limitations on the cover of this manual. • Always stay seated while riding the electric ride-on toy. To stop you must take your hand off the power button on the handlebar. • Children must be supervised by an adult at all times to be safe.
• Do not to allow hands, feet, hair, body parts, clothing, or similar articles to come in contact with wheels or other moving parts.
BEFORE YOU BEGIN ASSEMBLY B Remove all packing and items from the display box. Make sure that the handlebar connector and control module connector are disconnected before assembling the electric ride-on toy. ESTIMATED ASSEMBLY TIME You should allow approximately 20 minutes for assembly, not including initial charging time. Initial charging can take approximately 18 hours. (see page 11-12 for charging information).
PARTS DIAGRAM C Tools Required Screwdriver (not included) 1 9 2 Socket Wrench (included) 3 4 5 10 8 6 7 NOTE: Some parts shown are assembled on both sides of ride-on toy. 1. Handlebar Assembly x1 2 M5x15 Machine Screw x1 3. Seat x1 4. Hood x1 5. Plastic Body Assembly x1 6. 4 X 12 Round Head Screws x3 7. M10 Locknut x1 8. Ø10 washer x1 9. Socket Wrench x1 10.
ASSEMBLY D Your new ride-on toy requires adult assembly. Please set aside around 20 minutes for assembly. Please identify all parts before assembly and save all packaging material until assembly is completed to ensure that no parts are discarded. TOOLS REQUIRED: Phillips Screwdriver (not included) 17mm Socket Wrench (included) WARNING: Children can be harmed by small parts, sharp edges and sharp points in the ride-on toy's unassembled state, or by electrical items.
2. HANDLEBAR ASSEMBLY • Turn the ride-on toy upright. • Insert the handlebar assembly together with wire into the large opening at the front of the ride-on toy as shown. • Turn the ride-on toy on its side. • Ensure that the steering column is placed through the hole in the steering linkage attached to the front axle. • Install a Ø10 washer and M10 locknut, and then tighten them with the provided socket wrench. Steering Linkage M10 Locknut Ø10 Washer Steering Column 3.
4. SEAT ASSEMBLY • Insert the tabs at front of the seat into the slots in the ride-on toy body. • Then tighten the M5x15 machine screws with a screwdriver.
BATTERY CHARGING IMPORTANT! Before first time use, charge the battery for at least 18 hours. Charge the battery for at least 12 hours after each use of the ride-on toy. Never charge the battery longer than 30 hours. Overcharging or undercharging the battery may shorten battery life and decrease ride-on toy running time. WARNING: The battery can fall out and injure a child if the ride-on toy tips over. Always use the battery retainer. PREVENT FIRE • Never modify the electrical system.
• Use only an original charger (AC 120V 60Hz) with an output of DC 6V (0.5A) to charge your ride-on toy battery. • NOTE TO ADULTS: Regularly examine the charger for damage to the cord, plug, housing or other parts that may result in the risk of fire, electric shock or injury. • If your battery is old and will not accept a charge, do not leave it in the ride-on toy. Always remove a dead battery from the ride-on toy. • After the first charge, recharge the battery for at least 12 hours after each use.
HOW TO USE YOUR RIDE-ON TOY Power Button POWER BUTTON • To move the ride-on toy, press the power button. • To stop, release the power button.
IMPORTANT • Do not let any child touch the wheels or be near them when the ride-on toy is moving. • To avoid accidents, please inspect the ride-on toy before riding to ensure that it is in proper working order and safe to ride. • This toy has no brake; to stop, take your hand off the power button on the handlebar. • Check all the screws, cap nuts and protective coverings regularly and tighten as required. Check plastic parts on a regular basis for cracks or broken pieces.
DETAILED MAINTENANCE AND REPAIR Disconnect the handlebar connector from the control module connector before conducting any maintenance procedures. Phillips Screwdriver (not included) TOOLS REQUIRED: 17mm Socket Wrench (included) HOW TO REPLACE THE BATTERY 1 2 3 1. Unscrew the screw on the seat with a screwdriver and remove the seat. 2. Use a screwdriver to remove the two screws from the battery retainer. 3. Unplug the power connector (which is connected to the battery). 4. Remove the battery. 5.
BATTERY CARE AND DISPOSAL Do not store the battery in temperatures above 75° F (23.5° C) or below 32° F (0°C). THIS PRODUCT CONTAINS SEALED LEAD ACID BATTERIES WHICH MUST BE RECYCLED IN ACCORDANCE TO YOUR LOCAL AND STATE LAWS. PLEASE CAREFULLY READ AND UNDERSTAND THE FOLLOWING DISPOSAL INSTRUCTIONS: DISPOSAL: This product contains sealed lead acid batteries which must be disposed of or recycled in an environmentally safe manner. Do not dispose of the batteries in your household trash.
MAINTAINING YOUR RIDE-ON TOY Occasionally use a lightweight oil to lubricate moving parts such as wheels and the steering linkages. Park the ride-on toy indoors or cover it with a tarp to protect it from wet weather. Keep the ride-on toy away from sources of heat, such as stoves and heaters. Plastic parts may melt. ADULTS ONLY: Recharge the battery after each use. Recharge the battery at least once a month when the ride-on toy is not being used. DO NOT wash the ride-on toy with a hose.
TROUBLESHOOTING GUIDE Problem Possible Cause Solution Ride-on toy does not run Undercharged battery Charge the battery. A new battery should have been charged for at least 18 hours before using the ride-on toy for the first time. After first-time use, recharge the battery for at least 12 hours after each use. Never charge the battery longer than 30 hours. G Check all connectors.
Problem Possible Cause Solution Ride-on toy was running but suddenly stopped Loose wires or connectors Check all wires and connectors. Make sure the battery connector is tightly plugged into the power connector, and that there are no loose wires around the motor. Tripped fuse The fuse may “trip” and shut down operation of the ride-on toy if the ride-on toy is overloaded or the driving conditions too severe. Once a fuse has “tripped”, do not continuously push on the power button.
Problem Possible Cause Solution Ride-on toy runs sluggishly Undercharged battery Charge the battery. A new battery should have been charged for at least 18 hours before using the ride-on toy for the first time. After first-time use, recharge the battery for at least 12 hours after each use. Never charge the battery longer than 30 hours. Check all connectors. Make sure the battery connector is tightly plugged into the charger connector, and that the charger is plugged into the wall outlet.
Problem Possible Cause Solution Charger gets warm during use It is normal for some chargers to get warm during use and is not reason for concern No action required. If your charger does not get warm during use, it does not mean that it is not working properly. Some chargers do not get warm during use Battery makes a sizzling or gurgling noise when charging 21 It is normal for some batteries to make noise and swell slightly while charging and is not reason for concern No action required.
LIMITED WARRANTY H Subject to the following limitations, all electric ride-on toys manufactured for Dynacraft are warranted to the original purchaser to be free of defects in materials and workmanship for a period of one year from the date of purchase, except with respect to batteries, for which the limited warranty period is six months from the date of purchase. No other express or implied warranty is given.
Dynacraft Customer Service 1-800-551-0032 8AM to 5PM Eastern Standard Time DO NOT return this item to the store. STOP Please call Dynacraft for assistance. Please have the following information available when you call: Model Number: (sample: 8802-33) Production Date: (sample: 03.03.2015) Serial Number: (sample: DA0233HD00001) Having this information will be required and helps us handle your call more effectively. Dynacraft BSC, Inc.
