User Manual

QUICK ASSEMBLY TRAINING WHEELS MOUNTING

To attach the quick assembly training wheels to the frame, begin

with one side by pressing the pin as shown, and while keeping the

pin depressed insert the training wheel bracket into the square guard

until you hear a “click” (see figure 1). Test the connection by pulling

on the training wheel bracket to make sure it is securely fastened and

does not come out of the square guard.

Repeat the above steps to mount the training wheel on the other side.

Make sure that the training wheels are securely fastened

after mounting and prior to each ride.

PAGE 1
QUICK ASSEMBLY TRAINING WHEELS MOUNTING To attach the quick assembly training wheels to the frame, begin with one side by pressing the pin as shown, and while keeping the pin depressed insert the training wheel bracket into the square guard until you hear a “click” (see figure 1). Test the connection by pulling on the training wheel bracket to make sure it is securely fastened and does not come out of the square guard. Repeat the above steps to mount the training wheel on the other side.
PAGE 2
FOLDING PEDALS Push The pedals are already installed on your bike, but they are folded. Before riding the bike, the pedal must be unfolded as described below and in the accompanying figures. • Push the trigger and then unfold the pedal until you hear a “click” (see figure 1). • Make sure both trigger legs sit well in the square holes (see figure 2). If you need to replace the pedals, use a 6mm Allen wrench to disassemble the pedal from the crank (see figure 3).