User manual
Table Of Contents
- 1 Introduction
- 2 Controls, Indicators and Connections
- 2.1 Input Mono
- 2.2 Input Stereo
- 2.3 FX 1/2
- 2.4 AUX
- 2.5 MON
- 2.6 MASTER with GEQ
- 37 - USB 2.0 DIGITAL AUDIO INTERFACE
- 38 - MASTER LED-DISPLAY
- 39 - STANDBY
- 40 - MASTER L/R fader
- 41 - MASTER A OUT L/R
- 42 - POWER AMP INPUTS L/R
- 43 - MASTER B OUTPUTS L/R
- 44 - MASTER B
- 45 - PRE/POST of MASTER B
- 46 - STEREO/MONO of MASTER B
- 47 - PHONES
- 48 - PHONES
- 49 - REC SEND L/R
- 50 - REC SEND & USB OUT
- 51 - 9-BAND STEREO GRAPHIC EQUALIZER
- 2.7 DISPLAY with function keys
- 2.8 Stereo Power Amplifier
- 2.9 Rear panel
- 3 Display & functions
- 4 DIGITAL AUDIO INTERFACE
- 5 Setting up a standard PA
- 6 Master Patchbay and different setup alternatives
- 1 Einführung
- 2 Bedienelemente und Anschlüsse
- 2.1 Input Mono
- 2.2 Input Stereo
- 2.3 FX 1/2
- 2.4 AUX
- 2.5 MON
- 2.6 MASTER mit GEQ
- 37 - USB 2.0 DIGITAL AUDIO INTERFACE
- 38 - MASTER-Aussteuerungsanzeige
- 39 - STANDBY-Schalter
- 40 - MASTER L/R-Fader
- 41 - MASTER A OUT L/R-Buchsen
- 42 - POWER AMP INPUTS L/R-Buchsen
- 43 - MASTER B OUTPUTS L/R-Buchsen
- 44 - MASTER B-Regler
- 45 - PRE/POST-Schalter für MASTER B
- 46 - STEREO/MONO-Schalter für MASTER B
- 47 - PHONES-Buchse
- 48 - PHONES-Regler
- 49 - REC SEND L/R-Buchsen
- 50 - REC SEND & USB OUT-Regler
- 51 - 9-BAND STEREO GRAPHIC EQUALIZER
- 2.7 DISPLAY mit Funktions-Tasten
- 2.8 Stereo-Leistungsverstärker
- 2.9 Rückseite
- 56 - Netzbuchse
- Die Spannungsversorgung des PowerMate erfolgt ausschließlich mit dem mitgelieferten IEC-Netzkabel über eine verriegelnde Netzbuchse. Schließen Sie den PowerMate nur an eine geeignete Netzversorgung an, die den auf dem Typenschild angegebenen Anfor...
- 57 - Netzschalter (POWER)
- 58 - MIDI IN/OUT-Buchsen
- 59 - Speaker Outputs Right/Left
- 3 Display & Funktionen
- 4 DIGITAL AUDIO INTERFACE
- 5 Aufbau einer Standard-PA
- 6 Master Patchbay und verschiedene Aufbauversionen
- 7 Specifications
POWERMATE
3
77
Device in rated condition, unity gain (MIC gain 20 dB), all faders position 0 dB, all pots in mid position, master fader +8 dB, LPN HIGH, amplifier
load 8 ohms, dual channel, mains voltage 230 V/50 Hz or 120 V/60 Hz, unless otherwise specified.
Equivalent Input Noise, MIC input, A-weighted, 150 ohms -130 dBu
Noise, Channel inputs to Master A L/R outputs, A-weighted
Master fader down -100 dBu
Master fader 0 dB, Channel fader down -92 dBu
Master fader 0 dB, Channel fader 0 dB, Channel gain unity -82 dBu
Signal/Noise-Ratio, power amplifier, A-weighted, 4 Ohms 105 dB
Output Stage Topology, amplifier Class D
Equalization
LO Shelving
±15 dB / 60 Hz
MID Peaking
±12 dB / 2.4 kHz
HI Shelving
±15 dB / 12 kHz
Master EQ 9-band
(63, 125, 250, 500, 1k, 2k, 4k, 6.3k, 12k Hz)
±10 dB / Q = 1.5 to 2.5
Filter
LO-CUT, mono inputs f = 80 Hz, 18 dB/oct., switchable
Speaker Processing LPN, switchable
Effects
Type 2 x Stereo 24/48-bit multi effects processors
Effects presets 100 Factory + 20 User, Tap-Delay
Remote control Footswitch, MIDI
Display 128 x 64 pixels, OLED
Digital Audio Interface
Channels 4 In / 4 Out
AD/DA Conversion 24-bit
Sampling Rate 44.1 / 48 / 88.2 / 96 kHz
PC Interface USB2.0, Female Type B
Peak Display 6 dB before Clip
MIDI Interface 5-pin DIN connector, In / Out
Output Power Control (Speaker Protection) Adjustable longterm RMS Limiter
Protection
Mixer Outputs, relay controlled AUX, MON, MASTER A L/R
Amplifier Audio Limiters, High Temperature, DC, HF, Short Circuit, Peak Current Limiters, Turn-on Delay,
Back EMF
Switching Mode Power Supply (µC controlled) Inrush Current Limiters, Mains Over/Undervoltage, Mains Over Current, High Temperature
Cooling Continuous speed controlled Fans
Phantom Power, switchable 48 V DC
Power Requirements (SMPS with auto range mains input) 100 V to 240 V AC, 50 Hz to 60 Hz
Power Consumption, at 1/8 maximum output power, 4 Ohms 450 W
Safety Class I
Ambient Temperature Limits +5 °C to +40 °C (40 °F to 105 °F)
Dimensions (W x H x D), mm With lid:
438.8 x 161.7 x 362.5
Rack-mount:
483 x 135.8 x 310.3 (7 HU)
Weight
Net Weight, without lid 9.0 kg
Net Weight, with lid 9.5 kg
Shipping Weight 12 kg
Warranty 36 months
Optional Accessories
Rack Mount Kit F01U214880 (DC-RMK-600-3)
FS 11 (Footswitch with LED) F01U100598 (DC-FS11)
Carrying bag F01U259014 (DC-BAG-600PM)
Property PowerMate 600-3










