User Manual

Preset F1 --- F8/10**
Store Preset
U1 --- U50 U1 --- U50
Startup:
Last
F1 -- F8/10*
U1 --- U50
AMP Setup
Mode:
Normal
Bridged
Routing A:
In A In A
Routing B:
In B In A In B
In B In A+B
In A+B
DSP Edit
EQ A
EQ B
Delay A: 0 ms 0 --- 650 ms 0 --- 680 ft
Delay B: 0 ms
0 --- 207 m
GEQ A: OFF ON
GEQ B: OFF
LP/HP/Xover Freq. 30 - 300 Hz
Parameter: Unlinked Linked
GPI Config* I1:
None
*C Series
I2: U1 (Linear Dual)
None F1 --- F8/10** only!
F1 --- F8/10** U1 --- U50
U1 --- U50
Load Monitor
Imp. A:
Imp. B:
Lock
Front Control On / Off
Preset On / Off
AMP Setup On / Off
DSP Edit On / Off
USB On / Off
Reset On / Off
Lock
Pin Code:
0 0 0 0
Options
Name: Untitled
Brightness: 100%
Dim Level: 50%
Dim-Time: Off
Contrast: 5
Delay unit: ms
Ambient: 20 °C / 68 °F
Reset
Default settings? NO
YES NO
YES
Info
Name: Untitled
Model: L / C Series
Firmware: x.x.xx
Ontime: h:m
Standby time*: h:m
-20 °C --- +60 °C
Erase User Presets?
Meter - Feet - ms
days : h, after 1000 h
Load Preset
0 --- 100 %
0 --- 10
0 --- 100 %
Off / 10 --- 60 sec.
x.x Ohm / Open / Shorted / Invalid
x.x Ohm / Open / Shorted / Invalid
U1 (Linear Dual)
** See preset table
Dependent on preset
EQ 1-5: Enable (On/Off), Type (PEQ, Loshelv, Hishelv, Hipass, Lopass),
Frequency (20Hz - 20kHz), Gain (-18dB - +12dB), Quality (0.4 - 40.0), Slope
(6dB/Oct, 12dB/Oct)
Figure 7.2: DSP control menu
L Series and C Series FIR-Drive Power
Amplifiers
Power amplifier menu navigation | en 25
Bosch Sicherheitssysteme GmbH Installation manual 2017.10 | 02 | F.01U.327.801