User Manual

15
Bosch Security Systems, Inc. • 12000 Portland Ave South • Burnsville, MN 55337, USA • Phone: [phone] • Fax: [phone]
Subject to change without prior notice.
POWERMATE
3
/CMS
3
•Close the „VST Connections“ dialog. The inputs and outputs in Cubase LE 6 are now configured for recording
in live mode.
2. Adding Tracks
•Select the audio track „Audio 01“.
•Open the Channel section of the Inspector. The channel fader of the audio track is shown.
•Activate the loudspeaker icon „Monitor“ next to the channel fader.
•Use the REC SEND & USB OUT control of the PowerMate/CMS to set the level of the MAS L/R audio signal
sent via the DIGITAL AUDIO INTERFACE to the highest possible level without clipping. If the signal clips, the
„USB“ indication in the display of the PowerMate
3
/CMS
3
changes to „MASTER“.
•Use the channel fader in Cubase LE 6 to set the signal level so it never exceeds the marking in the VU meter.
•Repeat the last five steps for audio tracks „Audio 02“ and „Audio 03“. Use the AUX faders of the PowerMate
3
/
CMS
3
to set the level of the AUX 1/2 audio signal sent via the DIGITAL AUDIO INTERFACE. If the signal clips,
the „USB“ indication in the display of the PowerMate
3
/CMS
3
changes to „AUX 1“ or „AUX 2“
Illustration 34: Setting the level
Illustration 35: Marking in VU meter