User`s manual

User’s Manual
9
2.2 Switch Definition
First of all, configuring the dome ID and communication protocol is required before
connecting the dome camera to other devices. The switches used for configuring
these settings are located on the bottom of the dome camera.
Outdoor Dome
A
Reserved
B
Communication Switch
C
Dome ID Switch
D
Dome Control Protocol Switch
E
RJ-45 Connector (for IP dome only)
F
22-Pin Connector
2.3 Communication Switch Setting
The table below shows the function of each pin within the Communication Switch.
Communication Switch Pin 1
Pin 2
RS-485 Setting
Pin 3
Termination
Pin 4
Line Lock
Pin 5
System Initialization (for upgrade)
Pin 6
Reserved
RS-485 is the interface that communicates the dome camera and its control device;
for this reason, the RS-485 setup of the dome and the control device must be the