User`s manual

User’s Manual

The alarm will be triggered if the Exposure value changes; if the adjusted

AE value retains for four seconds, the value will be saved as the reference,

and the alarm will stop.

MOTION

Motion Detection function allow detecting suspicious motion and triggering

alarms when motion volume in the detected area reaches/exceeds the

determined sensitivity threshold value. The main menu is shown below:

• BLOCK MODE

In Motion Detect Mode, users can set Block Mode as “ON” or “OFF”. When

BLOCK MODE is turned on, if there are any variations (e.g. caused by

intrusion) in the sections of the monitoring image, the affected parts will be

highlighted dynamically.

• FRAME SET

In a monitored field, users can define specific areas as motion detection

target zones. Please refer to the instructions as follows to configure

parameters for each motion detection zone so-called “Frame.” When motion

is detected within a defined frame, a flash warning notice: MOTION, will

display in the upper left corner of the screen.

Total four frames can be set. Select a frame using the right/left keys on the

keyboard, and press “ENTER” key to enter the frame’s submenu, as shown

below.

FRAME SET 1

LEFT LIMIT L/R

TOP LIMIT D/U

H SIZE 000

V SIZE 000

MODE PRESET

PRESET POINT 001

DWELL TIME 001 SEC

EXIT YES

ALARM DETECT

DETECT SWITCH OFF

DETECT MODE MOTION

BLOCK MODE ON

FRAME SET 01

FRAME DISABLE 01

THRESHOLD 016

EXITD YES