User`s manual

User’s Manual

P/M Model:

Select one of the IR modes below through the right key on the control keyboard.

Press the <CAMERA MENU> key (ENTER) on the selected mode to enter its

submenu, which will be described later.

• AUTO

The Internal circuit will automatically decide the occasion to remove the IR

cut filter according to the image brightness level.

NOTE: When IR function is in AUTO mode, AE will automatically

become AUTO mode. Additionally, if AE is set as Shutter, Iris and

AGC priority mode, the IR AUTO function will be invalid. To resume

IR AUTO function in this case, users can 1) adjust AE to AUTO

mode; 2) adjust IR function to ON/OFF mode, and then switch back

to AUTO mode.

• ON

Select the item to remove the IR cut filter.

• OFF

Select the item to disable IR function.

NOTE: When Alarm Detect function (see section 3.3.19 ALARM

DETECT) is turned on, IR function will automatically switch to ON/OFF

mode.

Sub-menu of IR Function

THRESHOLD

The Dome Camera will remove the filter immediately when the threshold

value is reached. For the M model, the threshold options are <LOW>,

<MID> and <HI>. <LOW> threshold indicates a higher sensitivity and can

improve reliability of lens that it is easier to switch to Day mode and

relatively difficult to change into Night mode; while <HI> indicates that it is

easier to switch to Night mode and difficult to change into Day mode. For

the P Model, the IR threshold value ranges from <1> ~ <13>. At value <1>,

the camera will be most inclined to convert to color mode from B/W mode,

IR FUNCTION

THRESHOLD LOW

IR COLOR COLOR

EXIT＋SAVE YES