User`s manual

User’s Manual
53
3.3.14 AUTOPAN
Auto-pan means motion of scanning an area horizontally so that the Dome
Camera can catch horizontal view. The parameters are listed as follows.
• AUTOPAN LINE
There are four sets of auto-pan line built in a Dome Camera. Users can
choose a line to execute using LEFT/RIGHT direction keys. In addition,
users are able to command the Dome Camera to do endless panning by
setting the start point the same as the end point.
• START POINT
Follow the description below to set the start position of the AUTOPAN path.
1. Move the cursor to <START POINT> and press <ENTER> while the
item, <TO FIND>, is flashing. Then the item will turn <TO SAVE>
automatically.
2. Move the Dome Camera to a desired position and press <ENTER> to
save the position as the start point; the cursor will move to <END
POINT> automatically. Ensure setting the end point to complete
auto-pan setting.
NOTE: The tilt and zoom values of the start point will be recorded
and fixed for the selected Auto-pan line.
• END POINT
Users are able to set the end point after the start point is defined. Pan the
Dome Camera to another position and press <ENTER> to save the position
as the end point.
AUTOPAN
AUTOPAN LINE 1
START POINT TO FIND
END POINT TO FIND
DIRECTION RIGHT
SPEED 01
RUN AUTOPAN ENTER
EXIT YES