User`s manual

User’s Manual

3.3.13 SEQUENCE

The function executes pre-positioning of the pan, tilt, zoom and focus features

in a certain sequence for a camera. Before setting this function, users must

pre-define at least two preset points.

• SEQUENCE LINE

There are eight sets of sequence lines built in the Dome Camera. Using

LEFT/RIGHT direction keys to select a line first and then set its sequence

points.

• SEQUENCE POINT

Up to 64 points can be setup for each Sequence line. The Sequence Points

represent order of the preset points that the Dome Camera will automatically

run. The following setup items, including PRESET POSITION, SPEED and

DWELL TIME, will influence how the camera runs through each sequence

point.

• PRESET POSITION

Users can assign a specific preset position to the selected Sequence Point

with this item. Options include “1~256” and “END.” END is used for the

Sequence Point following the last Sequence Point when the amount of

sequence points (see the previous section) is less than 64 points.

NOTE: If not all 64 points are used, please set the point following the

last Sequence Point as “END” (PRESET POSITION) so that the

sequence line can work properly. For example, if a user intends to

set a Sequence Line with 5 sequence points. It is required to set the

PRESET POSITION of Sequence Point 06 as “END.”

SEQUENCE

SEQUENCE LINE 1

SEQUENCE POINT 01

PRESET POSITION 001

SPEED 01

DWELL TIME 001

RUN SEQUENCE ENTER

EXIT YES