User`s manual

User’s Manual

NOTE: Flip setting is manual-controlled only. If a Preset or a point

for other function (ex. Sequence) is set in the position that can only

be reached through FLIP motion, when Flip is off, the position

cannot be reached anymore.

OFF

Select this item to disable the flip function.

NOTE: To make the Dome Camera tilt between a specific range,

such as -10° to +100° or -10° ~ +190°, please go to ANGLE

ADJUSTER (see next section) to set the angle range of tilt.

Otherwise, the Dome Camera will tilt 90° as the default setting.

• ANGLE ADJUSTER

The item is for adjusting the angle range of tilt motion. The Range of the tilt

motion varies in different FLIP modes: the angle ranges from -10° to +100°

in the M.E. FLIP and FLIP OFF modes, and from -10° ~ +190° in the IMAGE

FLIP mode.

• SPEED BY ZOOM

If the item is set to <ON>, the pan/tilt speed will be automatically adjusted

by internal algorithm when zooming. The larger zoom ratio leads to the

lower rotating speed.

• AUTO CALI. (Auto Calibration)

There are one horizontal point and one vertical infrared rays check point in

each Dome Camera. During installation or maintenance, the Dome

Camera’s position may be moved. Therefore, the relative distance between

the original set point and the check point will be changed. If the Auto

Calibration function is enabled, the Dome Camera will automatically detect

the matter and reset the horizontal point back to the original position.

ANGLE ADJUSTER

ADJUST MIN ANGLE -10DEG

ADJUST MAX ANGLE 100DEG

EXIT + SET YES