User Manual

Problem Procedure
Battery does not
power the computer
as long as expected
If you frequently recharge a partially charged
battery, the battery might not charge to its full
potential. In these instances, you should fully
discharge the battery and then attempt to charge it
again.
Real-Time Clock
Problem Procedure
BIOS setting and
system date/time are
lost
The lasting time of the Real-Time Clock (RTC) has
run out. You must set the date and time in the
BIOS setup utility by using the following steps:
1. Launch the BIOS setup utility.
Refer to the BIOS setup utility section for
further information.
2. Set the date in the System Date field.
3. Set the time in the System Time field.
4. Follow the on-screen instructions to proceed.
BIOS
Problem Procedure
Computer cannot be
powered on
Disconnect the AC adaptor for several seconds
and then reconnect the AC adaptor. After that,
press the power button.
If it still does not work, press and hold the power
button for about 15 seconds.
If it still does not operate properly, you should
contact your reseller or dealer.
Keyboard
Keyboard problems can be caused by the setup and configuration of the
computer. Refer to the The Keyboard section for further information.
Problem Procedure
Output to screen is
garbled
Refer to your software documentation to ensure
that it is not remapping the keyboard in any way
(remapping involves changing or reassigning the
function of each key).
If you are still unable to use the keyboard, you
should contact Technical Support.
User's Manual 6-6