User Manual

This section explains how to remove and install the battery pack, and
begins with the removal process which is detailed through the following
steps.
Do not remove the battery pack while the computer is in Sleep Mode,
as data is stored in RAM, so if the computer loses power it might be
lost.
In Hibernation Mode, data will be lost if you remove the battery pack or
disconnect the AC adaptor before saving is completed.
Do not remove the battery pack when you are charging your computer
by connecting the AC adaptor via the USB Type-C™ adapter (e.g.
USB-C™ to HDMI™/VGA Travel Adapter). Otherwise, the computer
cannot be powered on properly.
Do not touch the battery release latch while holding the computer, or
the battery pack might fall out due to the unintentional release of the
battery release latch and cause injuries.
Removing the battery pack
To remove a discharged battery, do the following:
1. Save your work.
2.
Click Start ->
(Power) and then click Shut down while holding
down the SHIFT key. Ensure that the Power indicator is off.
3. Remove all cables and peripherals that are connected to the
computer.
4. Close the display panel and turn the computer upside down.
5. Slide the battery lock into its unlocked (
) position.
6. Slide and hold the battery release latch to disengage the battery pack
and then lift it up to remove it from the computer.
Figure 4-8 Releasing the battery pack
2
1
3
1. Battery lock
3. Battery pack
2. Battery release latch
Installing the battery pack
To install a battery pack, do the following:
User's Manual
4-23