User Manual

System ON CDP Charge
This function enables/disables CDP (Charging Downstream Port) to use
rapid USB charge while the computer is powered on. When "System ON
CDP Charge Mode" is enabled, your computer can supply USB bus power
(DC5V, 1.5A) to the compatible ports while the computer is turned on.
To set System ON CDP Charge Mode, click Start -> dynabook Settings
-> USB Charge.
Enabled Rapid USB battery charge at maximum 1.5A
while PC is powered On.
Disabled Conventional USB battery charge while PC is
powered On.
The "System ON CDP Charge Mode" might not work with certain external
devices even if they are compliant with the USB specifications. In those
cases, use a USB port without "Power Off and Charge function" or disable
“System ON CDP Charge Mode”.
It is recommended that the AC adaptor be connected to the computer while
supplying USB bus power (DC5V, 1.5A).
When your computer battery capacity is too low to continue, "System ON
CDP Charge Mode" might not work. In those cases, connect the AC
adaptor and reboot the computer.
Always use the USB cable that was included with your USB device.
When "System ON CDP Charge Mode" or “Power Off and Charge function”
is enabled, the “USB Wakeup” function might not work. In that case, use a
USB port without "Power Off and Charge function" or disable both “System
ON CDP Charge Mode” and “Power Off and Charge function”.
System Password
The System Password tab allows you to set a password in order to restrict
access to the computer. Two levels of password security are provided:
User and Supervisor.
Passwords set by the System Password function are different from the
Windows password.
User Password
To set a user password, click Start -> dynabook Settings -> System
Password.
User authentication may be required to validate user rights when using
System Password to delete or change passwords, and so on.
User's Manual
5-7