User Manual

High-power radars are allocated as primary users (i.e. priority users) of the
bands 5.25 to 5.35 GHz and 5.65 to 5.85 GHz and these radars could
cause interference and/or damage to LE-LAN devices.
Australia and New Zealand regulatory compliance
This equipment incorporates a radio transmitting device. When used in the
Clamshell mode, a separation distance of 20 cm from the antennas will
ensure the radio frequency exposure level complies with the Australian and
New Zealand Standards.
Using this equipment in Japan
In Japan, the frequency bandwidth of 2,400 MHz to 2,483.5 MHz for
second generation low-power data communication systems such as this
equipment overlaps that of mobile object identification systems (premises
radio station and specified low-power radio station).
1. Important notice
The frequency bandwidth of this equipment may operate within the same
range as industrial devices, scientific devices, medical devices, microwave
ovens, licensed radio stations and non-licensed specified low-power radio
stations for mobile object identification systems (RFID) used in factory
production lines (Other Radio Stations).
1. Before using this equipment, ensure that it does not interfere with any
of the equipment listed above.
2. If this equipment causes RF interference to other radio stations,
promptly change the frequency being used, change the location of
use, or turn off the source of emissions.
3. Contact an authorized service provider if you have problems with
interference caused by this product to Other Radio Stations.
2. Indication for Wireless LAN
The indication shown below appears on this equipment.
(1)(2) (3)(4)
(5)
1. 2.4 : This equipment uses a frequency of 2.4 GHz.
2. DS : This equipment uses DS-SS modulation.
3. OF : This equipment uses OFDM modulation.
4. 4 : The interference range of this equipment is less than 40 m.
5.
: This equipment uses a frequency bandwidth from 2,400 MHz
to 2,483.5 MHz. It is possible to avoid the band of mobile object
identification systems.
User's Manual
7-14