Use and Care Manual

NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
C) FUEL FILTER IN FUEL TANK
Clean twice per heating season or as needed
1) Pull Fuel Line off from Fuel Filter neck.
2) Turn Fuel Filter 90˚ to counter clockwise and pull to remove.
3) Remove Fuel Cap and Fuel Cap Filter.
4) Wash Filters with clean kerosene and replace in tank.
5) Attach Fuel Line to Fuel Filter neck.
D) BURNER FULL ASSEMBLY REMOVAL
E) PHOTOCELL
Clean Photocell annually or as needed.
8
Figure 4. Tank Fuel Filter Removal
Figure 5. Burner Full Assembly Removal
Figure 6. Photocell Removal
1) Remove Back Cover(See Page7)
2) Disconnect Cooling M/T Wire from Control PCB.
3) Remove Fuel Line from Fuel Filter.
4) Remove Power Cord from U-shaped Hole in the shell.
5) Remove 3nuts with 8mm socket wrench and remove
Burner Full Assembly from Shell Insulator.
1) Remove Back Cover(See Page7)
2) Disconnect Photocell Wire from Control PCB.
3) Remove Photocell from Photocell Bracket.
4) Push Photocell Wire to arrow direction.
5) Clean Photocell Lens with cotton swab.
If Photocell Lens is damaged, Replace new one.
6) Replace Photocell to Bracket.
7) Replace Photocell Wire and Back Cover.
Fuel Tank
Fuel Filter
Fuel Cap Filter
Fuel Line
Photocell Wire
Control PCB
Bracket
Photocell
Photocell
Wire
Photocell
Lens
Cooling M/T Wire
Control PCB
Fuel Line
Fuel Filter
Shell
U-Shaped Hole
Power Cord
Shell Insulator
Burner Full Assembly
NUT