Use and Care Manual

NEVER LEAVE THE HEATER

UNATTENDED WHILE BURNING!

Figure 2. Packing Materials

Figure 3. Assembling Handle, Heat Shield

1. UNPACKING

REMOVE THE HEATER AND ALL PACKING

MATERIALS FROM THE BOX.( Fig. 2 )

NOTE : Save the shipping carton and packing materials

for future storage.

2. ASSEMBLY

Tools Required

• Medium Phillips Screw driver.

3. UNPACKING AND ASSEMBLY

Bolt

Remove Bolts

Bolt

Handle

Shell

Shell Ring

Heat Shield

Handle

Heat Shield

1. Remove the pre-assembled Bolts on the shell

and shell ring.

2. Align the holes in the shell with two mounting

holes on the handle as shown in Figure3.

3. Secure handle with Bolts.

4. Align the holes in the shell ring with two

mounting holes on the heat shield as shown in

Figure 3.

5. Secure heat shield with Bolts.

CAUTION : DO NOT operate heater without heat shield assembled to the heater.

The heat shield must attached to prevent any damage, discoloration, or deformation to the floor.

NOTE : Heater should be inspected before each use, and at least annually by a qualified service person.