Use and Care Manual

10
NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
Figure 9. Tighten Fuel Pipe
Figure 10. Electric Pump removal
Figure 11. Fan Removal
H) FUEL PIPE
Tightening Fuel Pipe annually or as needed.
1) Remove Back Cover.(See Page 7)
2) Remove Burner Full Assembly.(See Page 8)
3) Tighten Fuel Pipe at Electronic Pump and at Burner
Body using 12mm wrench.
4) Inspect Fuel Line for damage.
If damaged or cracked, Replace Fuel Line.
I) ELECTRONIC PUMP
Replace Electronic Pump if broke or damaged.
J) FAN BLADES
Clean every season or as needed.
COOLING FAN
BLOWER FAN
Fuel Line
Electronic Pump
Fuel Pipe
Burner body
Burner
Supportor
Fuel Pipe
Electronic
Pump
Pump Wire
Clamp
Fuel Line
Bolt
Heater Assembly
Screw
Shell Supportor
Spring
Cooling
Fan
Motor
Cooling
Photocell Wire
RPM Sensor Wire
Blower Motor Wire
Blower Motor Assembly
Bolt
Set Screw
Blower Fan
Fan Cover
Screw
Burner Supporter
1) Remove Back Cover.(See Page 7)
2) Remove Burner Full Assembly.(See Page 8)
3) Remove Fuel Pipe from Electronic Pump and Burner
Body(See page 8)
4) Loosen Clamp with long nose plier and remove Fuel
Line from Electronic Pump.
5) Remove Pump wire from Electronic Pump.
6) Remove 2bolts with medium phillips screwdriver and
remove Electronic Pump from Burner Supporter.
7) Inspect Electronic pump for damage or break down.
If break down or damaged, replace Pump.
8) Replace Electronic pump to Burner Supporter.
9) Replace Pump wire and Fuel Pipe.
10) Replace Burner full assembly & Back Cover.
1) Remove Back Cover.(See Page 7)
2) Remove Burner Full Assembly.(See Page 8)
3) Remove 4 screws with medium phillips screwdriverand
remove Heater Assembly from Shell Supporter.
4) Remove Spring from Cooling Fan and Slip Cooling Fan off
from Cooling Motor Shaft.
5) Clean Fan using a soft cloth moistened with kerosene or
solvent.
6) Dry Fan Blade thoroughly.
7) Replace Fan and Heater Assembly.
8) Replace Burner Full Assembly and Back Cover.
1) Remove Back Cover.(See Page 7)
2) Disconnect 3Wires from Control PCB.(See Figure 11)
3) Remove 3 Bolts with medium phillips screwdriver and
remove Blower Motor Assembly from Burner Supporter.
4) Remove 3 Screws with medium phillips screwdriver and
remove Fan Cover from Blower Motor Aassembly.
5) Use 2mm allen wrench to loosen set screw and slip Blowr
Fan off from motor shaft.
6) Clean Fan using a soft cloth moistened with kerosene or
solvent.
7) Dry Fan Blade thoroughly.
8) Replace Fan and Blower Motor Assembly.
9) Replace 3 wires and Back Cover.