Installation Instructions

ManualsBrandsDyna-Glo ManualsHeaterRMC-FA300DGD

IMLPF300DGD - KEJ

Operating Instructions & Parts Manual RMC-FA300DGD

Dyna-Glo

Delux

Propane Construction Heater

PROFESSIONAL GRADE

Description

Dyna-Glo

Delux Model RMC-FA300DGD heaters are 300,000 BTU/Hr construction

heaters. This heater uses propane gas for combustion, and electricity to run the

fan. It is primarily intended for temporary heating of well-ventilated buildings

under construction, alteration or repair. This heater should be utilized in sheltered,

well-ventilated areas, but never in occupied dwellings.

C US

Figure 1 - Model RMC-FA300DGD

Output Rating Maximum Fuel Regulator

Model BTU/Hr Fuel Consumption Ignition Outlet Pressure

RMC-FA300DGD 300,000 Propane Vapor Only 13.9 lb/h Direct Spark, Interrupted 7-10 PSIG

Hot Air Output Minimum Supply Maximum Supply Size

Model Approx. (CFM) Motor Pressure to Regulator Pressure to Regulator L x W x H (Inches) RMC-RMC-

FA300DGD 1800 0.085 HP 25 PSIG (For purposes Max Bottle Pressure 33.7 x 12.6 x 18.5

1,720 RPM of input adjustment)

Table of Contents Page

Description .......................1

Speciﬁcations......................1

Unpacking ....................... 1

General Safety Information ........1-3

Theory of Operation................3

Installation......................3-4

Ventilation........................4

Operation ......................4-5

Maintenance ....................5-6

Storage ..........................6

Wiring Diagram....................6

Repair Parts Illustration

and Parts List ....................7-8

Troubleshooting Chart ..............9

Warranty ........................11

Unpacking

1. Unpack all materials used to protect

the heater inside of carton. Retain

plastic caps attached to exposed

ﬁttings for use during storage.

2. Remove heater, accessories and all

hardware from carton.

3. Inspect all items for damage that may

have occurred during shipment.

GENERAL HAZARD

WARNING

FAILURE TO

COMPLY WITH THE PRECAUTIONS AND

INSTRUCTIONS PROVIDED WITH THIS

HEATER, CAN RESULT IN DEATH, SERIOUS

BODILY INJURY AND PROPERTY LOSS,

OR DAMAGE FROM THE HZARARDS OF

FIRE, EXPLOSION, BURN. ASPHYXIATION,

CARBON MONOXIDE POISONING, AND/

OR ELECTRIC SHOCK.

ONLY PERSONS WHO CAN UNDERSTAND

AND FOLLOW THE INSTRUCTIONS

SHOULD USE OR SERVICE THIS HEATER.

IF YOU NEED ASSISTANCE OR HEATER

INFORMATION SUCH AS AN INSTRUCTION

MANUAL, LABELS, ETCETERA, CONTACT

THE MANUFACTURER.

General Safety Information

IMPORTANT: Be sure to read and

understand all cautions and warnings,

before operating this heater. Keep

this instruction manual for future

reference, and use it as a guide to safe

and proper operation of the heater.

Various precautions appear throughout

this manual. Please review and pay

close attention to them. Below is an

explanation of the various levels of

caution required while operating this

heater.

DANGER

Indicates an im minen tly

hazardous situation

which, if not avoided, WILL result in death

or serious injury.

WARNING

Indicates a poten tially

hazardous situation

which, if not avoided, COULD result in

death or serious injury.

CAUTION

Indicates a poten tially

hazardous situa tion

which, if not avoided, MAY result in minor

or moderate injury.

WARNING

FIRE, BURN,

INHALATION, AND

EXPLOSION HAZARD, KEEP SOLID

COMBUSTIBLES, SUCH AS BUILDING

Model Electrical Input Amperage

RMC-FA300DGD 120 V, 60 Hz 0.65

Electrical Speciﬁcations

General Speciﬁcations

WARNING

(6.3 kg/h)

(85.6 x 32 x 47 cm)

Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described. Protect yourself and

others by observing all safety information. Failure to comply with instructions could result in personal injury and/or property damage! Retain instructions for

future reference.

Speciﬁcations

Printed in China

www.ghpgroupinc.com

ANS Z83.7-2011 CSA 2.14-2011 Construction Heater

RMC-FA300DGD

Summary of content (12 pages)

PAGE 1
RMC-FA300DGD Operating Instructions & Parts Manual Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described. Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or property damage! Retain instructions for future reference.
PAGE 2
RMC-FA300DGD Dyna-GloTM Delux Operating Instructions and Parts Manual Dyna-GloTM Propane Construction Heater NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! MATERIALS, PAPER OR CARDBOARD, A SAFE DISTANCE AWAY FROM THE HEATER AS RECOMMENDED BY THE INSTRUCTIONS. NEVER USE THE HEATER IN SPACES WHICH DO OR MAY CONTAIN VOLATILE OR AIRBORNE COMBUSTIBLES, OR PRODUCTS SUCH AS GASOLINE, SOLVENTS, PAINT THINNERS, DUST PARTICLES OR UNKNOWN CHEMICALS.
PAGE 3
Dyna-GloTM Delux Operating Instructions and Parts Manual Models RMC-FA300DGD NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! • Gas supply connections should be checked using a 50/50 solution of liquid dish soap and never use a flame to check for gas leaks. • The electrical connection & grounding must comply with National Electrical Code. ANSI/NFPA 70 or in Canada CSA C22.1, Canadian Electrical Code, Part 1. Use only a properly grounded three (3) prong receptacle.
PAGE 4
RMC-FA300PF/DG/DGD RMC-FA300DGD TM & Dyna-GloTM Operating Instructions and Parts Manual ProFitterTM Dyna-Glo Delux Operating Instructions and Parts Manual Dyna-GloTM& Dyna-Glo ProFitter TM TM Propane Construction Heater NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! Installation Installation Review Review and and under understand stand all all of ofthe the warnings warnings in in the theSafety SafetyInformation Information Section Section on on pages pages1–3. 1–3.
PAGE 5
Dyna-GloTM Delux Operating Instructions and Parts Manual Model RMC-FA300DGD NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! Operation (Continued) Maintenance FAN Do not adjust the regulator above 10 PSIG or below 7 PSIG, or the heater may not operate properly. Do not attempt to service the heater while it is hot, operating or plugged in. Severe burns or electrical shock can occur. IMPORTANT: Always remove the fan from the motor shaft before removing the motor assembly from the heater.
PAGE 6
RMC-FA300PF/DG/DGD RMC-FA300DGD TM TM ProFitterTM & Dyna-Glo Operating Instructions andManual Parts Manual Dyna-Glo Delux Operating Instructions and Parts Dyna-Glo ProFitter & Dyna-Glo TM TM TM Propane Construction Heater NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! Maintenance (Continued) IGNITOR The only onlymaintenance maintenance necessary necessary for for the ignitor ignitorisistoto sure that bebe sure that the the gapgap between theelectrodes electrodes is kept between between the is kept be
PAGE 7
RMC-FA300PF/DG/DGD RMC-FA300DGD TM TM Dyna-Glo Delux Operating Instructions and Parts Manual ProFitterTM & Dyna-Glo Operating Instructions and Parts Manual For Repair Parts, call 1-877-447-4768 24 hours a day – 365 days a year Please provide following information: -Model number -Serial number (if any) -Part description and number as shown in parts list NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! 1 3 5 6 7 8 12 13 14 18 17 15 19 16 26 9 10 4 20 22 11 28 53 56 57 55 27 31 29 32 3
PAGE 8
RMC-FA300DGD Dyna-GloTM Delux Operating Instructions and Parts Manual Model RMC-FA300DGD Use only original WARNING replacement parts. This Heater must use designspecific parts. Do not substitute or use generic parts. Improper replacement parts could cause serious or fatal injuries. NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! Repair Parts List for Propane Construction Heater Ref. No. Description Part No. Qty.
PAGE 9
RMC-FA300DGD RMC-FA300PF/DG/DGD TM TM Dyna-Glo Delux Operating Instructions and Parts ProFitterTM & Dyna-Glo Operating Instructions andManual Parts Manual Dyna-Glo ProFitterTM& Dyna-Glo TM TM Propane Construction Heater Troubleshooting Chart Symptom Possible Cause(s) Corrective Action NEVER LEAVE THE HEATER Fan does not turn when 1.
PAGE 10
PAGE 11
RMC-FA300DGD Dyna-GloTM Delux Operating Instructions and Parts Manual LIMITED WARRANTY: This limited warranty is extended to the original retail purchaser of this Forced Air/Convection/Radiant Heater and warrants against any defect in materials and workmanship for a period of one (1) year from the date of retail sale. GHP Group, Inc.
PAGE 12
WARRANTY REGISTRATION IMPORTANT: We urge you to fill out your warranty registration card within fourteen (14) days of date of purchase. You can also register your warranty on the internet at www.ghpgroupinc.com. Complete the entire serial number. Retain this portion of the card for your records. GHP Group, Inc. 6440 W Howard St Niles, IL 60714-3302 Tel: (877) 447-4768 www.ghpgroupinc.com SAVE THIS CARD! Place Postage Stamp Here GHP Group, Inc.