Owners Manual

11
12
12
Install the batteries in the battery case, and fill the Cartridge tank with clean, pure kerosene. Set the tank into the
heater and wait at least 60 minutes for the new wick to fully saturate with kerosene.
Reinstall the wind cover.
Remove the wick adjusting knob
once again, if it was reinstalled
before.
Reinstall the cabinet.
Tighten 5 screws on the
cabinet
Reinstall the chimney and the
cartridge tank.
Reinstall the wick adjusting
knob. Close the front grille.
42 petS32 petS22 petS
Step 27Step 26Step 25