Owners Manual

1010

WICK REPLACEMENT

Wick replacement should be performed on a completely cool heater after the cartridge tank has been removed and

the remainder of the kerosene in the heater has been burned off.

Use only genuine replacement wick.

Replacement wick number : Glowick 200-B, Kero-World 20401-U, Dura Heat DH-200, Pick-A-Wick-PW27.

Remove the screw on the wind

cover.

Unscrew 4 wing nuts.

Remove the wick adjuster

assembly.

Remove the wick from the holder

by folding it toward the center

loosening it from the sharp

metal teeth on the inner surface

of the holder, and slide it out.

Remove the wind cover. Remove the automatic ignition

Assembly by unscrewing 2 screws.

6 petS5 petSStep 4

3 petS2 petS

9 petS8 petS7 petS

Step 1

Open the tank cover and

remove the cartridge tank.

Remove the batteries to

prevent possible burns.

Open the front grille and

remove the chimney.

Remove the wick adjusting

knob by pulling straight out.

Unscrew 5 screws, two from the

back and one from the right side

and two from the left side of the

cabinet.

Remove the cabinet.

By pulling it straight up.