Use and Care Manual

12
11. Put the ame screen (B) over the upper
plate (E). Make sure the holes on the side
of the ame screen (B) are aligned with the
holes on the upper plate (E).
Connect the xing brackets (FF) to the
upper plate (E) and ame screen (B) with
three M5 x 12 mm screws (EE).
Make sure the xing brackets (FF) are
securely xed to the protective guards (O).
Then tighten the screws with the Phillips
screwdriver (OO).
12. Assemble the reector panel (A) onto the
ame screen (B).
WARNING: Be sure to remove the
protective lm from the reector panel
(A) before assembly.
Screw the three reector spacers (CC) into
the pre-drilled holes in the ame screen
(B) and tighten with the wrench (GG).
Put three washers Φ8 (BB) onto the top
of the reector spacers (CC). Then put
the reector panel (A) onto the reector
spacers (CC), securing them with three
washers Φ8 (BB) and three wing nuts (AA).
ASSEMBLY INSTRUCTIONS
Hardware Used
Hardware Used
11
12
Phillips
screwdriver
Reector
Space
M5 x 12 mm Screw
Wing Nut
Fixing Brackets
Washer Φ8
x 3
x 3
x 3
x 3
x 6
EE
AA
FF
BB
OO
CC
EE
FF
B
A
B
E
O
CC
BB
AA
Wrench
GG