Installation Guide

13. NOTE: If you have a separate table accessory please

follow the instructions below to change or access the

propane tank.

To change or access the propane tank, you will need

to completely unscrew the nut and move the table

and nut all the way up to the top of the post. Lightly

tighten. Use the assistance of a second person to

hold up the cylinder housing while you tend to the

propane tank.

Connect regulator and hose assembly (RR) to propane

cylinder (not included). The propane gas and cylinder are

sold separately.

CONNECTING GAS CYLINDER

Use only 20-pound cylinders (approximately 18 ¼ inches

high and 12 ¼ inches in diameter) equipped with a

cylinder connection device compatible with the connection

for outdoor cooking appliances. The gas cylinder should

not be dropped or handled roughly!

Minimum Gas Supply Pressure : 5.0 psi / 35 kPa

Maximum Gas Supply Pressure Bottle pressure

Outlet prssure setting of regulator is 11.0 in. W.C / 2.74 kPa -LPG.

Storage of an appliance indoors is permissible only if the cylinder is disconnected and removed from the

appliance. A cylinder must be stored outoors in a well-ventilated area out of the reach of children.

A disconnected cylinder must have dust caps tightly installed and must not be stored in a building, garage

or any other enclosed area.

The minimum hourly of 17000Btu/H / 4.98 KW is required input rating for a heater for automatic operation

at ratings less than full input rating.

The pressure regulator and hose assembly supplied with the appliance must be used. The installation

must conform with local codes, or in the absence of local codes, with national fuel gas code, ANS Z223.1/

NFPA54, natural gas and propane Installation Code, CSA B149.1, or propane storage and handling code,

B149.2.

ASSEMBLY INSTRUCTIONS

Hardware Used

x 6

Washer Φ 8

12. Hold the heater steady while sliding three washers

8 (GG) over threaded end of reector spacer (FF).

Position reector assembly over three spacers (FF).

Install three washers

8 (GG) on reector spacers

(FF) and securely tighten with three M8 wing nuts

(KK) but do not overtighten.

x 3

M8 Wing nut