Instructions / Assembly

CARE AND MAINTENANCE

• Gas odor with extreme yellow tipping of flame.

• Heater does NOT reach the desired temperature.

• Heater glow is excessively uneven.

• Heater makes popping noises.

• Spiders and insects can nest in burner or orifices. This dangerous condition can damage heater and

render it unsafe for use. Clean burner holes by using a heavy-duty pipe cleaner. Compressed air

may help clear away smaller particles.

• Carbon deposits may create a fire hazard. Clean dome and burner screen with warm soapy water if

any carbon deposits develop.

Note: In a salt-air environment (such as near an ocean), corrosion occurs more quickly than normal.

Frequently check for corroded areas and repair them promptly.

TIP:

Use high-quality automobile wax to help maintain the appearance of your heater. Apply to exterior

surfaces from the pole down. Do not apply to emitter screen or domes.

Storage

Between uses:

• Turn off control valve and cylinder valve.

• Disconnect the hose regulator from propane cylinder.

• Store heater upright in an area sheltered from direct contact with inclement weather (such as rain,

sleet, hail, snow, dust and debris).

• If desired, cover heater to protect exterior surfaces and to help prevent build-up in air passages.

Note: Wait until heater is cool before covering.

During periods of extended inactivity or when transporting:

• Turn Control Knob OFF.

• Disconnect the hose regulator and move the cylinder to a secure, well ventilated outdoor location.

• Store heater upright in an area sheltered from direct contact with inclement weather (such as rain,

sleet, hail, snow, dust and debris).

• If desired, cover heater to protect exterior surfaces and to help prevent build-up in air passages.

Never leave LP cylinder exposed to direct sunlight or excessive heat.

Note: Wait until heater is cool before covering.

Service

Only a qualified service person should repair gas passages and associated components.

Caution: Always allow heater to cool before attempting service.

• Turn off cylinder valve.

Signs of possible blockage include: